FMT Swiss AG 23 190, Инструкция по эксплуатации и меры безопасности

Страница: 13 / 32

13
Operating instructions - digital oval gear meter and pulse meter
US
5. The display will show all the segments again. Only then follows
the phase where all segments are switched off. Finally, there
will be a display showing the total that has been reset (RESET
TOTAL).
7.2 Output of liquid with display of current flow rate (Flow Rate Mode)
It is possible to output a liquid and have the following displays available at the same time:
■ ■
Partial volumes having been output
■ ■
Current flow rate (Flow Rate) in [unit of partial volume per min.], as shown below.
This is how you get into this mode:
■ ■
Wait until the meter is in default standby mode (i.e. the display shows only the total volume).
■ ■
Press TOTAL shortly.
■ ■
Start output operation.
The display of the current flow rate will be updated every 0.7 secs. For that reason the display may ‚flutter‘
somewhat with low flow rates. However, the higher the flow rate, the more stable the display will be.
NOTE
The current flow rate will be shown in the unit set for the partial volume register.
That means if partial and total volume have been set to different units (as shown in
the example below) you must bear in mind that the flow rate shown is in the unit
set for partial volumes. In the example shown, the flow rate is in QTS./min.
The word GAL next to the flow rate refers to the register of the (resettable and NON-resettable) total
volumes which will be displayed again as soon as you leave the ‚current flow rate‘ display mode.
In order to go back to the default standby mode, press the TOTAL button again.
Accidental pressing of the RESET or TOTAL button does not have any effect in this state.
NOTE
RESET TOTAL and absolute total (TOTAL) are not shown in this mode.
However, the values nevertheless go up. You can check after fluid discharge.
Wait for the default standby mode and press TOTAL shortly.
7.2.1 Resetting partial volumes
In order to reset the partial volume register, you must first complete the output of liquid. Wait until the
display shows a flow rate of 0.0 (see fig.) and then press RESET shortly.