Get your model ready to fly
2.
adjust the servo arm by using the trim function on your radio.
Note
: For computerized transmitters, use the servo/channel sub-trim feature to make each
servo arm fully vertical. Make sure the trims and the sub trims in neutral position before
making some mechanically trim.
Adjust the servo arms mechanically make sure all servo arms are fully vertical. If not,
3.
The standard hole settings for linkage connections are shown by the black arrows in the
the diagram below. You can move the linkage to different hole positions to increase
control surface travel and increase the aerobatics of the airplane.
4.
counterbalance leading
edge of the rudder with the vertical stabilizer leading edge.
Note
Align the control surfaces well by adjusting the linkage rod in the control connector.
The ailerons align with the wing root fillet, the counterbalance leading edge of the
elevator with the horizontal stabilizer leading edge and the
: Use a drop of thread lock on the grub screws before securing the linkage rod.
page13
4
