FMS FMS11221RTRGN, Инструкция по эксплуатации

Страница: 13 / 44

13
EN
Getting started
Before operation, install the battery and connect the system as instructed below.
Danger
Do not expose to excessive heat or liquids.
Danger
Do not open, disassemble, or attempt to repair the battery.
Danger Do not crush/puncture the battery, or short the external contacts.
Danger
Do not use the battery if damaged.
Danger
Do not drop the battery or expose to strong shocks or vibrations.
Danger
Always store the battery in a cool, dry place.
Danger
Only use specified battery (X4 AA batteries).
Transmitter Battery Installation
1.Open the battery compartment cover.
2.Insert 4 fully-charged AAA batteries into the compartment. Make sure that the battery makes good contact with the
battery compartment's contacts.
3. Replace battery compartment cover.
Battery Type: AAA
Battery Installation:
Low battery alarm: When the battery is lower than 4.2V, the LED on the panel will flash slowly.
Instructions
After setting up, follow the instructions below to operate the system.
1. Automatic code matching (the transmitter and receiver have been successfully coded before leaving the
factory.)
1. When the transmitter power is on and the code matching mode is on, the light keeps flashing;
2. The power supply of the receiving board is turned on, and the front lights keep flashing to enter the code matching
mode;
3. When the code matching is successful, all the transmitter lights are on and all the lights on the car are off;
If you need to replace another transmitter or receiver, please follow the following steps to code:
Note: when code matching, please operate the transmitter to enter the code matching state first, and then operate the
receiver to enter the code matching state.