FMS EMGZ300, Руководство по эксплуатации

Страница: 4 / 16

Operating manual EMGZ300
4
2 Definitions
Offset:
Correction value for compensation of the zero point difference. Thanks to the offset, it is
ensured that a force of 0N will generate a signal of 0V exactly.
Gain:
Amplification factor for the measuring signal. Use of proper value will set the measuring
range of the sensor exactly corresponding to the signal output range (0...10V).
Strain gauge:
Electronic component that will change its resistance while its length has changed. Strain
gauges are used in the FMS force sensors for acquisition of the feedback value.
3 System components
The EMGZ300 consists of the following components (refer also to fig. 1):
Force sensors
•
For mechanical/electrical conversion of the tension force
•
Force measuring bearing
•
Force measuring roller
•
Force measuring journal
•
Force measuring bearing block
Electronic unit EMGZ300
•
Hybrid module for supplying the force sensors and amplification of the mV signal
•
One single electronic board may contain up to 4 hybrid modules
•
Variable or fixed values for gain and offset
•
Freely configurable lowpass filter
•
Freely configurable outputs (±10V; 0...20mA; 4...20mA)
•
For mounting into insert card support block EMGZ555959 (by mounting into control
cabinet)
•
With aluminium front panel for mounting into 19“ rack
•
Supports connection of an external feedback display
(Italic components as variant or option)