FMS EMGZ Series, Руководство по эксплуатации

Страница: 27 / 41

Operating Manual EMGZ611A...614A
27
Config. Dig.Out.A
Use: This parameter defines which event will activate the digital output
A. The digital output is operated as „open collector“ output (ref. to
wiring diagram).
Range: Min., Max., Error, Okay Default: Error
Config. Dig.Out.B
Use: This parameter defines which event will activate the digital output
B. The digital output is operated as „open collector“ output (ref. to
wiring diagram).
Range: Min., Max., Error, Okay Default: Error
Lowpass output
Use: Each channel provides a lowpass filter to prevent noise which is
added to the output signal. This parameter stores the cut off
frequency. The lower the cut off frequency, the more sluggish the
output signal on the terminals will be (ref. to wiring diagram). Due
to this filter, the output signal will be much more stable in the
case of high fluctuations of the force value.
Range:
0.1 to 200.0
Default: 10.0
Increment: 0.1 Unit: [Hz]
Scale output
Use: This parameter stores which tension feedback value will give the
maximum signal (10V resp. 20mA) at the output.
Range: A force value can be input. The value consists of 4 digits. The
position of the decimal point depends on the parameter Force of
sensor.
Default: -
Unit: [N, kN, cN] or [lb, klb, clb]
Configuration output
Use: This parameter configures the analog output signal.
Range: 0–10V and 0...20mA, Default: 0–10V
and 0–10V and 4...20mA, –10V...+10V 0...20mA
Note (only for subprint Rev. C)
Jumper Settings and Parametrisation (Configuration output) have to coincide