FMS BKS015, Руководство по эксплуатации

Страница: 12 / 36

Operating Manual BKS015
26.11.2018 12
The sensor is mounted on the right side of the frame and
controls the material on right edge or on the line, if a line
sensor is used. One sensor is necessary. The LED indicates
the right edge guiding mode.
Two sensors are mounted on both sides of the frame. The
frame is controlled in a way that the material position is kept
centered with regard to both sensor positions. The LED
indicates the centre guiding mode.
Key to enter the Parameter Setting Mode. Hold the key for
longer then 3 sec. The LED above the PARA key lights. A
second press for longer then 3 sec. on the PARA key will store
the value (ref. to 6.6 “Entering the Parameter Setting”)
With this key you can select between automatic or manual
mode. The LED indicates the automatic mode.
Drive to center position. The frame moves to the center
Position. This function is only available in manual mode.
In manual mode the frame will move to the left in 0.1mm
steps by pressing the button once. By pressing the button
longer than 1 sec. it will continuously move the frame to the
left.
In automatic mode the Reference Position will be adjusted to
the left in 0.1 mm steps by pressing the button once. Pressing
the button longer than 1 sec. it will continuously move the
Reference Position to the left (see chapter 6.4)
In parameter setting mode: Pr
essing the button reduces
continuously the parameter value.
In manual mode the frame will move to the right in 0.1mm
steps by pressing the button once. By pressing the button
longer than 1 sec. it will continuously move the frame to the
right.
In automatic mode the Reference Position will be adjusted to
the right in 0.1 mm steps by pressing the button once.
Pressing the button longer than 1 sec. it will continuously
move the Reference Position to the right. (see chapter 6.4) “.
In parameter setting mode: Pressing the button increases
continuously the parameter value.
Fig. 6: Table of key functions
6.4 Operation in Automatic Mode