FMS 1:24 FCX24 MAX SMASHER, Инструкция по эксплуатации

Страница: 13 / 28

13
Battery Type: AAA
Battery Installation:
1.Open the battery compartment cover.
2.Insert 4 fully-charged AAA batteries into the compartment. Make sure that the battery makes good contact with
the battery compartment's contacts.
3. Replace battery compartment cover.
Low battery alarm: When the battery is lower than 4.2V, the LED on the panel will flash slowly.
After setting up, follow the instructions below to operate the system.
1. Automatic code matching (the transmitter and receiver have been successfully coded before leaving
thefactory.)
If you need to replace another transmitter or receiver, please follow the following steps to code:
a. When the transmitter power is on and the code matching mode is on, the light keeps flashing;
b. The power supply of the receiving board is turned on, and the front lights keep flashing to enter the code matching
mode;
c. When the code matching is successful, all the transmitter lights are on and all the lights on the car are off;
Note: when code matching, please operate the transmitter to enter the code matching state first, and then operate
the receiver to enter the code matching state.
2.Power off
Follow the steps below to turn off the system:
a. Disconnect the receiver power.
b. Toggle the transmitter's power switch to the [OFF] position.
Danger Do not drop the battery or expose to strong shocks or vibrations.
危险
如果不按照说明方法操作，可能导致操作者或他人遭受较大伤害。
Danger Always store the battery in a cool, dry place.
危险
请将电池存放在干燥阴凉的环境中。
Danger Do not use the battery if damaged.
危险
如果电池损坏，请立即停止使用。
关闭时，请务必先关闭接收机电源，再关闭发射机，否则可能导致模型损坏、人员受伤。
Danger Make sure to disconnect the receiver power before turning off the transmitter. Failureto do so
may lead to damage or serious injury
危险
电池类型使用：AAA电池
请按照以下步骤安装发射机电池：
1.打开电池仓盖。
2.将4颗电量充足的AAA电池装入电池仓内，确保电池上的金属端子与电池仓内的金属端子接触。
3.盖好电池仓盖。
低电量报警：当电量低于4.2V时，面板上的LED慢闪报警提示。
Instructions
操作指引
准备操作完成后，您可以按照本章指引开始使用本产品。
1.自动对码（发射机和接收机在出厂前已对码成功）
2.关机
如需更换其他的发射机或接收机请按照如下步骤进行对码:
a.按住Bind键后，发射器电源打开，对码模式，灯不停闪亮;
b.接收板电源打开，前车灯不停闪亮，进入对码模式；
c.当对码成功，发射机灯全亮，车上面的灯全部关闭；
注意：对码时请先操作发射机进入对码状态，再操作接收机进入对码状态。
请按照以下步骤关机：
a.断开接收机电源。
b.将开关拨到［OFF］位置，使发射机关闭。