FMS 1:12 TOYOTA FJ45 Pick-up, Инструкция по эксплуатации

Страница: 4 / 36

Safety symbols
Safety guide
RADIO SYSTEM
Danger Not following these instructions may lead to serious injuries or death.
Warning Not following these instructions may lead to major injuries.
Attention Not following these instructions may lead to minor injuries.
Prohibited
Mandatory
4
EN
Pay close attention to the following symbols and their meanings. Failure to follow these warnings
could cause damage, injury or death.
• Do not use the product at night or in bad weather like rain or thunderstorm. It can cause
erratic operation or loss of control.
• Do not use the product when visibility is limited.
• Do not use the product on rain or snow days. Any exposure to moisture (water or snow)may
cause erratic operation or loss of control.
• Interference may cause loss of control. To ensure the safety of you and others, do not
operate in the following places:
1
、
Near any site where other radio control activity may occur
2
、
Near power lines or communication broadcasting antennas
3
、
Near people or roads
4
、
On any body of water when passenger boats are present
• Do not use this product when you are tired, uncomfortable, or under the influence of alcohol
or drugs. Doing so may cause serious injury to yourself or others.
• The 2.4GHz radio band is limited to line of sight. Always keep your model in sight as a large
object can block the RF signal and lead to loss of control.
• Do not touch any part of the model that may generate heat during operation, or immediately
after use. The engine, motor or speed control, may be very hot and can ause serious burns.
• Misuse of this product may lead to serious injury or death. To ensure the safety of you and
your equipment, read this manual and follow the instructions.
• Make sure the product is properly installed in your model. Failure to do so may result in
serious injury.
• Make sure to disconnect the receiver battery before turning off the transmitter. Failure to do
so may lead to unintended operation and cause an accident.
• Ensure that all servos operate in the correct direction. If not, adjust the direction first.
• Make sure the model stays within the systems maximum range to prevent loss of control.