FMS 1:12 TOYOTA FJ45 Pick-up, Инструкция по эксплуатации

Страница: 12 / 36

12
Throttle stick position
THROTTLE STICK POSITION
Neutral point Top point of forward direction Top point of backward direction
Instructions
EN
Battery Type: AAA
Battery Installation:
1.Open the battery compartment cover.
2.Insert 4 fully-charged AAA batteries into the compartment. Make sure that the battery makes good
contact with the battery compartment's contacts.
3. Replace battery compartment cover.
Low battery alarm: When the battery is lower than 4.2V, the LED on the panel will flash slowly.
After setting up, follow the instructions below to operate the system.
1. Automatic code matching (the transmitter and receiver have been successfully coded before
leaving the factory.)
If you need to replace another transmitter or receiver, please follow the following steps to code:
1. When the transmitter power is on and the code matching mode is on, the light keeps flashing;
2. The power supply of the receiving board is turned on, and the front lights keep flashing to enter the
code matching mode;
3. When the code matching is successful, all the transmitter lights are on and all the lights on the car
are off;
Note: when code matching, please operate the transmitter to enter the code matching state first, and
then operate the receiver to enter the code matching state.
Charging the Battery
1.Connect the charger to a USB port then connect the battery to the charger.
2.When charging,the Green LED is flash, when charged, the Green LED is stable.
3.Do not let the battery charge unattended!
4. If the battery or charger is hot,disconnect the battery and charger immediately as this may be
caused by an internal short-circuit.
1. Connect the charger's USB port to
a power source.
2. Connect the battery to the charger.