FMI LDV43NE, Руководство владельца по эксплуатации и установке

Страница: 29 / 44

www.fmiproducts.com
125898-01D 29
other airborne particles to cling to the glass
form on the glass due to paint curing. The
glass should be cleaned several times with a
non-ammonia, nonabrasive household clean-
of operation. Thereafter, clean the glass two
or three times during each heating season,
depending on the usage and circumstances
present. Refer to Removing/Replacing Glass
Door , page 22 of this manual when removing
glass door for cleaning.
-
Replacement Parts ,
-
If glass has been broken, carefully remove
glass door (see Removing/Replacing Glass
Door
a shop vac.
CAUTION: Do not vacuum if
Use only glass door replacement intended for
Replacement Parts , page
may be made. See Removing/Replacing
Glass Door , page 22 for instructions for re-
placing glass doors.
CLEANING AND MAINTENANCE
Continued
-
latched, removed, cracked or
PILOT AND BURNERS
and replace when cleaning is complete.
compressed air to remove dust, dirt or lint.
brush to remove excess dust, dirt or lint.
Conduct annual inspection of the venting
system following these guidelines:
1. Check areas of venting system that are
exposed to the weather for corrosion (rust
spots or streaks and, in extreme cases,
-
-
light into the vent. Remove any foreign
material.
3. Check for evidence of excessive con-
densation. Continuous condensation can
and can be caused by having excessive
lateral runs, too many elbows or exterior
portions of the system being exposed to
cold weather.
-
ened. Check mechanical supports such
as wall straps for rigidity.