www.fmiproducts.com
124531-01C
21
TROUBLESHOOTING
Continued
2%6(59('352%/(0
ODS/pilot lights but flame
JRHV RXW ZKHQ FRQWURO NQRE
is released
Burner does not light after
ODS/pilot is lit
Delayed ignition of burner
%XUQHUEDFN¿ULQJGXULQJFRP
-
bustion
REMEDY
1. Press in control knob fully
$IWHU2'6SLORWOLJKWVNHHS
control knob pressed in 30
seconds
3. Fully open equipment shut-
off valve
4. A) Contact local natural or
propane/LP gas company
B) Clean ODS/pilot (see
Cleaning and Maintenance
page 19) or replace ODS/
pilot assembly
+DQG WLJKWHQ XQWLO VQXJ
then tighten 1/4 turn more
6. Replace pilot assembly
7. Replace control valve
1. Clean burner (see
Cleaning
and Maintenance
SDJH
RUUHSODFHEXUQHURUL¿FH
2. Contact local natural or
propane/LP gas company
1. Contact local natural or
propane/LP gas company
2. Clean burner (see
Cleaning
and Maintenance
SDJH
RUUHSODFHEXUQHURUL¿FH
1. Clean burner (see
Cleaning
and Maintenance
SDJH
RUUHSODFHEXUQHURUL¿FH
2. Replace damaged burner
3. Replace gas regulator
3266,%/(&$86(
1. Control knob not fully
pressed in
2. Control knob not pressed in
long enough
3. Equipment shutoff valve not
fully open
4. Pilot flame not touching
WKHUPRFRXSOH ZKLFK DO
-
ORZVWKHUPRFRXSOHWRFRRO
FDXVLQJ SLORW ÀDPH WR JR
out. This problem could be
caused by one or both of
WKHIROORZLQJ
$/RZJDVSUHVVXUH
B) Dirty or partially clogged
ODS/pilot
5. Thermocouple connection
loose at control valve
6. Thermocouple damaged
7. Control valve damaged
%XUQHURUL¿FHFORJJHG
2. Inlet gas pressure is too
ORZ
1. Manifold pressure is too
ORZ
%XUQHURUL¿FHFORJJHG
%XUQHURUL¿FHLVFORJJHGRU
damaged
2. Damaged burner
3. Gas regulator defective
