www.fmiproducts.com
126363-01B
9
Figure 5 - Installing Hood
Screw
Hood
Rail
INSTALLATION
Continued
Figure 6 - Assembling Perimeter Trim
Side Trim
Slot
Mitered
Edge
Slot
Shim
Set Screws
Adjusting
Plate
Assembled
Trim
Top
Trim
Figure 7 - Attaching Perimeter Trim to
Fireplace
Trim
Hanging
Screws
Hanging
Notches
on Trim
Mitered
Edge
ASSEMBLING AND ATTACHING
OPTIONAL PERIMETER TRIM
IMPORTANT:
If you are recessing the firebox
in a wall, do not attach trim at this time. See
Built-In Fireplace Installation
, page 11.
Note: These instructions show assembling
and attaching trim to fireplace.
CHECK GAS TYPE
Use the correct gas type (natural or propane/
LP) for your fireplace. If your gas supply is not
correct, do not install fireplace. Call dealer
where you bought fireplace for proper type
fireplace.
WARNING: This appliance is
equipped for natural or propane/
LP gas but not both. Gas type is
indicated on rating plate. Field
conversion is not permitted.
ELECTRICAL HOOKUP
This fireplace includes a blower which must
be connected to either a wall receptacle or
the electrical receptacle that is included within
the fireplace. If the receptacle included with
the fireplace is to be used, it must be wired
to a 120 volt supply by a certified electrician.
OPTIONAL PANELS
Each fireplace is shipped with louvered panels
installed. Smooth panels are also shipped
with this fireplace and be used if desired.
They allow for a different appearance. The
smooth panels may be covered with noncom
-
bustible materials such as ceramic tile or rock.
INSTALLING HOOD
Install hood to rail already installed in fireplace
as shown in Figure 5. Use 3 Phillips screws
provided.
1. Remove packaging from three pieces
of trim.
2. Locate four screws, two adjusting plates
with set screws, and two shims in the
hardware packet.
3. Align shim under adjusting plate as shown
in Figure 6.
4. Slide one end of adjusting plate/shim
in slot on mitered edge of top trim (see
Figure 6).
5. Slide other end of adjusting plate/shim
in slot on mitered edge of side trim (see
Figure 6).
6. While firmly holding edges of trim to-
gether, tighten both set screws on the
adjusting plate with slotted screwdriver.
7. Repeat steps 1 through 6 for other side.
8. Tighten trim hanging screws (#10 x 6.25
shoulder) into holes in cabinets. Place
the assembled trim onto fireplace cabinet.
Align hanging notches on trim with hang
-
ing screws on side of fireplace (see Figure
7). Push trim firmly into place, sliding
hanging notches over hanging screws.
