FMI FEF18, Руководство пользователя

Страница: 8 / 10

TROUBLESHOOTING
WARNING : Turn off the appliance, unplug and let cool for at least 10 minutes before attempting
to service. Only a qualified professional should attempt to service or repair the appliance.
Æ
Flame is dim or not
present
2. Dimmer control button is set too
low.
3. Light bulbs are burned out.
4. Flame wand has come loose
from bracket.
5. Flame wand motor is not
functioning.
2. Push button FLAME HIGH
to increase light.
3. Inspect light bulbs and replace if
necessary. (see Maintenance
section of this manual)
4. Remove back panel. Secure
end of flame wand back into the
support bracket.
5. Call FMI Technical Service at
1-866-328-4537.
The appliance turns off
and will not turn back on
1. The overheat protection device in
the appliance has been triggered.
2. House circuit breaker has been
tripped.
1. Turn all controls off, unplug the
appliance, allow to cool for at
least 10 minutes, then plug back
in and restart.
2. Reset house circuit breaker.
The appliance does not
turn on when the button is
pushed to ON
2. The overheat protection device in
the appliance has been triggered.
2. Turn all controls off, unplug the
appliance, allow to cool for at
least 10 minutes, then plug back
in and restart.
Remote control does not
work
1. Low batteries.
2. Manual controls on the appliance
must be
Before operating
the remote control.
1. Replace all batteries in the
remote control.
2. Push the appliance using
the manual control panel, then
use remote control to operate.
If using the remote control to
operate the appliance, you must
also turn the Appliance
using the remote control.
Problem Possible Cause
Corrective Action
1. Flame not turned ON
1. Push FLAME ON/OFF button
1.No power to heater
8
1. Check to see the heater is
plugged in to 120V receptacle .
Check to see breaker is on.