3
105072
OWNER’S MANUAL
PRODUCT
IDENTIFICATION
Figure 1 - Ember Master
Install and use heater with care. Follow all
local codes. In the absence of local codes, use
the latest edition of The National Fuel Gas
Code, ANS Z223.1, also known as NFPA 54*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
Note:
Where listed vented decorative logs are
required, thermostat operation is not permitted.
CAUTION: Do not remove the
metal data plates from the grate
assembly. The data plates contain
important product information
1.
Remove logs and heater base assem-
bly from carton.
Note:
Do not pick up
heater base assembly by burners. This
could damage heater. Always handle
base assembly by grate.
2.
Remove all protective packaging ap-
plied to logs and heater for shipment.
3.
Check all items for any shipping dam-
age. If damaged, promptly inform
dealer where you bought heater.
PRODUCT
FEATURES
OPERATION
This heater is clean burning. It requires no
outside venting. There is no heat loss out a
vent or up a chimney. Heat is generated by
realistic, dancing yellow flames. This heater
is designed for vent-free operation with flue
damper closed. It has been tested and ap-
proved to ANS Z21.11.2 standard for unvented
heaters. State and local codes in some areas
prohibit the use of vent-free heaters. This
heater may also be operated as a vented deco-
rative (ANS Z21.60) product by opening the
flue damper (non-thermostat operation only).
SAFETY PILOT
This heater has a pilot with an Oxygen Deple-
tion Sensing (ODS) safety shutoff system.
The ODS/pilot is a required feature for vent-
free room heaters. The ODS/pilot shuts off
the heater if there is not enough fresh air.
PIEZO IGNITION SYSTEM
This heater has a piezo ignitor. This system
requires no matches, batteries, or other
sources to light heater.
OPTIONAL REMOTE
CONTROL ACCESSORIES
There are four optional remote controls that
can be purchased separately for this log
heater:
• wall switch
• wall thermostat
• hand-held ON/OFF remote
• hand-held thermostat remote
See Accessories, page 24.
The wall thermostat or hend-held thermo-
stat may not be used where vented decora-
tive listing is required.
14. Turn heater off and let cool before servic-
ing, installing, or repairing. When using
the hand-held remote accessory, make sure
the selector switch is in the OFF position.
Only a qualified service person should in-
stall, service, or repair heater.
15. When using the hand-held remote acces-
sory, make sure the selector switch is in
the OFF position when you are away
from home for long periods of time.
16. This heater must not be connected to
any external electrical source.
17. Operating heater above elevations of
4,500 feet may cause pilot outage.
LOCAL CODES
SAFETY
INFORMATION
Continued
Front
Logs
Crossover Log
Rear Log
Rear
Burner
Bottom
Middle Log
Base Assembly
Control Knob
Front
Burner
Piezo
Ignitor
Top Middle
Log
UNPACKING
