www.fmiproducts.com
119315-01D
18
OPTIONAL WALL SWITCH - GWMS2
(Remote-Ready Models Only)
WARNING: Read and fol-
low installation instructions.
Installation should be done by
a qualified installer familiar with
low-voltage wiring procedures.
WARNING: Do not connect
this switch to any electrical
source! Electrical shock and/or
fire hazard will occur.
1. Connect one terminal of 25 ft. wire to
“TPTH” terminal on control valve (see
Figure 19, page 17).
2. Connect remaining wire terminal to the
“TH” terminal on the control valve. Make
sure that wire terminals are in the posi-
tions on your unit as pictured in Figure
19, page 17. If wires are not “crossed”
the thermostat will not work.
3. Route the 25 ft. wire to a convenient loca-
tion to mount your wall switch (no outside
walls).
WARNING: Do not connect
the switch to a power source.
Electrical shock and/or fire haz
-
ard will occur.
IMPORTANT:
The wire may be shortened but
must not be lengthened.
4. Connect one bare wire end to each of the
terminals of the provided wall switch.
5. Install the wall switch and cover in the
wall.
INSTALLING LOG SET AND SCREEN
1. Remove log packaging material and discard
packaging. Gently place log over the burner
(see Figure 22). Do not allow log to contact
flame. If flame contacts log, soot will be
created.
2. Reattach screen by placing the notches
in the screen frame over the shoulder
screws and pushing down.
iNsTallaTioN
Continued
Log
Shoulder Screw
Screen
Figure 22 - Installing Log and Screen
opERaTiNG FiREplaCE
MaNUal-CoNTRollED
MoDEls
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol-
low these instructions exactly,
a fire or explosion may result
causing property damage, per
-
sonal injury or loss of life.
A. This appliance has a pilot which must
be lighted by hand. When lighting
the pilot, follow these instructions
exactly.
b. bEFORE LIGHTING smell all around
the appliance area for gas. be sure to
smell next to the floor because some
gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor’s phone. Follow the
gas supplier’s instructions.
• If you cannot reach your gas supplier,
call the fire department.
C. Use only your hand to push in or turn
the gas control knob. Never use tools.
If the knob will not push in or turn by
hand, don’t try to repair it, call a quali
-
fied service technician or gas supplier.
Force or attempted repair may result in
a fire or explosion.
