www.fmiproducts.com
116192-01Q
27
FIREPLACE INSTALLATION
Continued
INSTALLING BRICK LINER MODELS
BL36D-A(S-A) AND BL36DH-A(S-A)
WARNING: If fireplace has
been running, turn off unit. Let
cool before installing brick liner.
You may purchase brick liner from your local
retailer or see
Accessories
, page 37.
CAUTION: Always handle
brick panels with two hands.
Do not force brick panels into
place. Excessive force will break
brick panels.
1. Remove top and bottom louvers to allow
access to door latches.
2. Unlock door latches and open glass door.
See
Removing Glass Door
, steps 1 and
2, page 25.
3. Carefully remove lava rock and ember
material. Remove log/grate assembly
by unscrewing grate from plenum. The
two logs under the grate are attached to
burner. DO NOT attempt to remove.
4. Remove screws that attach plenum to
burner to remove plenum.
5. Remove three screws from deflector
shield on the inside top of firebox. Set
shield and screws aside.
6. Install rear brick panel first. Rest bottom
edge of panel on back edge of burner
assembly (see Figure 43).
7. Install left side brick panel by sliding it
between burner assembly and side of
firebox (see Figure 43).
8. Install right brick panel using same
method described in step 6 for left brick
panel.
9. Replace deflector shield using screws
removed in step 4.
10. Using screws removed in step 4, replace
plenum and attach to burner.
11. Using screws removed in step 3, replace
log/grate assembly. Be careful when
replacing log/grate assembly not to chip
logs on burner.
12. Install lava rock and glowing embers. See
Installing Lava Rock and Glowing Embers
,
page 26.
13. Close glass door and lock latches on top
and bottom of door and replace screen.
See
Removing Glass Door
, steps 5 and
6, page 25.
14. Close top and bottom louvers.
Figure 43 - Installing Rear Brick Panel
Rear Brick Panel
Left Side
Brick Panel
