www.fmiproducts.com
116192-01Q
26
Figure 42 - Placing Ember Material on
Burner
Ember Material
Plenum
FIREPLACE INSTALLATION
Continued
INSTALLING LAVA ROCK AND
GLOWING EMBERS
It is very important to keep logs exactly as
installed. Do not modify logs. Only use log
set designed for this fireplace. Logs under
log/grate assembly are attached to burner.
Do not attempt to move these logs as this
will damage logs.
WARNING: Logs are unitized
and attached to the grate. Do not
handle log/grate assembly by
logs. Always pick up by grate.
Open louvers, remove screen, unlock door
latches and open glass door. See
Removing
Glass Door
, steps 1 and 2 page 25.
1. Pull ember material apart into pieces no
larger than a dime. Place these pieces
loosely and sparingly directly onto ex
-
posed front section of burner (see Figure
42). This will create the glowing ember
appearance as flame touches ember ma
-
terial. Do not block air slots by using too
much ember material in one area.Place
small pieces of ember material to cover
pilot ports. It is not necessary to use all of
the ember material provided.
2. Pour lava rock onto plenum but not onto
flat burner. It is not necessary to use all
of the lava rock provided.
NOTICE: Do not put lava rock on
burner or under burner. Placing
lava rock on burner will cause
performance problems.
3. Close glass door, lock door latches,
replace screen and close louvers (see
Removing Glass Door
, steps 5 through
7, page 25.
7. Replace louvers by reversing procedure
under
Removing Louver Panels,
page 25
for TC36 series.
8. Replace screen door assembly, see remov
-
ing screen door assembly, page 25, for
TCC36 series.
Cleaning Glass Door
See
Cleaning and Maintenance
on page 30.
WARNING: The glass door
must be securely in place before
running this fireplace. Do not run
this fireplace if glass is missing
or broken.
