FM HARBIL 24018, Инструкция пользователя

Страница: 35 / 81

TESTING SHAKE MOTOR
5G Paint Mixer Instruction Manual 35
TESTING
SHAKE MOTOR Read all of the following instructions. If you have any doubt about
performing these procedures, please contact Fluid Management.
For component location and identification, refer to the Parts Section of this
manual.
1. Place an empty pail on the table and close the door firmly. Turn on the
paint mixer and push the START button. Give the paint mixer enough
time to lower the top plate onto the pail.
2. Turn off the paint mixer and unplug the electrical cord.
3. Remove the lower front and right side panels.
4. Remove the motor cover.
5. Take a 3-conductor jumper cable, which has a plug at one end and
stripped wires on the other end, and connect the wires to the shake
motor.
6. Plug the jumper cord into a wall outlet (120 volts or appropriate volt-
age).
• If the shake motor starts to run, then the cable or the relay is bad.
• If the shake motor does not run, it has to be replaced.
7. Unplug and remove the jumper cord from the shake motor.
8. Reassemble the mixer by returning the motor cover and lower panel to
their correct positions.
To carry out this test you will need 120 volts
which could cause electrical shock.
WARNING: ELECTRICAL HAZARD