10
REPAIR
If your Micro Calypso becomes damaged you can use white
glue, foam safe CA glue or clear tape to make repairs. You
can also order replacement parts (found on page 3 of this
manual) if your parts are beyond repair.
TROUBLESHOOTING GUIDE
PROBLEM:
Transmitter LED does not illuminate when
turned on.
Solution:
Batteries are installed into the transmitter incorrectly.
Remove batteries and check polarity markings on transmitter.
Solution:
The transmitter batteries are bad. Replace the
batteries.
PROBLEM:
Micro Calypso does not power up.
Solution:
Micro Calypso battery needs to be charged.
PROBLEM:
Rudder or elevator control surfaces are not
neutral when the trims on the transmitter
trims are centered.
Expand
Compress
Solution:
The “U” shaped servo linkage needs to be adjusted.
Compress or expand the “U” portion of the linkage until the
control surfaces are neutral. Use the transmitter trim to fine
tune the control surfaces.
PROBLEM:
Rudder or elevator moves in the opposite
direction it is supposed to.
Solution:
Adjust the servo reversing on the transmitter.
PROBLEM:
Flight time is short.
Solution:
The flight battery was not fully charged. Charge again.
Solution:
Flying conditions may be too cold (below 60 degrees
Fahrenheit [15.56 degrees Celsius]).
Solution:
The flight battery needs to be replaced.
Solution:
Replace the transmitter batteries with fresh batteries.
Содержание micro calypso
Страница 11: ...11 NOTES ...
Страница 12: ... ...
