4
Linking with the Airplane
●
Linking is already completed by factory setting.
●
If the model does not respond with the transmitter on and
the battery plugged in, you may need to link the airplane
to the transmitter.
●
A “humming” sound is normal when the battery is plugged
into the plane and does not mean the model is not
working properly.
1. Stick must be in the middle position to press down. Turn the
transmitter power on while pressing in on the left stick (You
will hear a ‘click’ when you press on the end of the stick.)
Beep
Beep
Beep
Red LED Location
2. The transmitter will start beeping and the green power LED
will fl ash for 20 seconds. Plug the battery into the receiver
unit, while the transmitter is beeping.
3. When the beeping stops or the LED on the receiver unit is
a steady light, the linking is complete.
4. When the linking procedure is successful, the LED on the
receiver will stay solid red when both the transmitter and
the receiver are turned on.
LED Display
ON
Rapid Flash
Slow Flash
ON
OFF
Power On
Battery Low
Bind Mode
Charge On
Charge Completed or Charge Off
Transmitter LED
Green LED Red LED
State
ON
Receiving Signals
OFF
Indicates that the power is off
or no signal reception
Slow Flash
The throttle stick is up in the ‘ON’ position
Rapid Flash
Battery Low
Receiver LED
Red LED
State
Red LED
Green LED
CHOOSING YOUR FLYING FIELD
●
The size of the hall etc. should be as shown in the diagram.
(Be sure to obtain appropriate permission.) The INUM can
be fl own in smaller areas with some experience.
Control may be lost if the airplane is more than
160 feet [50 meters] from the transmitter. Fly the
airplane within a 160 foot range.
16 ft / 5m
30 ft / 9 m
30 ft / 9 m
30 ft / 9 m
30 ft / 9 m
Содержание Inum
Страница 8: ...8...
