Flyzone cessna corvalis, Инструкция по эксплуатации

Страница: 12 / 20

12
Trainer
Switch
CH5 Switch
CH6 Dial
LED Power
Indicator
Power
Switch
Reversing
Switches
Neck Strap
Eyelet
D/R Switch
Trim
Lever
Charge
Jack
TACTIC TTX600 2.4 GH
Z
6-CHANNEL RADIO
Transmitter Batteries
Four “AA” batteries are required to power the Tx (not included). Non-rechargeable 1.5V alkaline, or 1.2V rechargeable nickel-
cadmium (NiCd) or nickel-metal hydride (NiMH) cells, can be used. Do not mix cell types, or old and new cells, etc.
To install the batteries, slide the battery door down. Insert the cells as shown
in the diagram, making sure to note proper polarity for each cell. Close the
battery door.
POWER SWITCH, LED, and LOW BATTERY ALARM
The red power LED should light when the power switch is moved upwards
to the “ON” position. The Tx should have adequate power for fl ight when the
LED is on constantly. Anytime the LED begins to fl ash, accompanied by the
sounding of an audible tone, the Tx battery voltage has dropped too low
and operation of the model should NOT be attempted!
WARNING! Never operate an R/C model with weak Tx batteries! Reduced operational range and/or
possible loss of control of the aircraft could result. Replace weak alkaline batteries, or re-charge NiCd or
NiMH batteries, before attempting a fl ight!
If during a fl ight the Tx LED starts to fl ash, accompanied by the sounding of audible tones, it’s a warning that the Tx batteries
have become weak and the aircraft should be landed as soon as possible!
Adjustable Sticks
The length of both gimbal sticks can be adjusted as desired. Loosen the set screw inside the
center of the stick with a 2mm hex wrench. Rotate the stick end counter-clockwise to lengthen
the stick, or clockwise to shorten the stick. Once the desired stick length is found, tighten the
set screw with the hex wrench.