FlyTek ZIP PRO 4, Руководство по эксплуатации и обслуживанию, Страница: 17 / 24

Remove the machine from the packaging and place it on a stable and horizontal surface, suitable to
support its weight, near a suitable socket. The machine must be installed in a room with a minimum
temperature of 15°C and maximum of 25°C. In addition, we recommend keeping the packaging and all its
parts for possible future transport.
INSTALLATION
CONNECTION TO THE WATER NETWORK
CONNECTION TO THE ELECTRIC NETWORK
The coffee pouring spouts are located in the front part of the machine.
If the external cable of the machine is damaged, it must be replaced with a special cable supplied
by the Manufacturer or by the assistance service.
COFFEE POURING SPOUTS (ref. b)
During pouring do not touch the spouts and do not approach your face to the
hot parts of the machine (burns hazard). The heating surfaces of the machine
are subject to residue heat even after use!
17
In the lower part of the machine there is a steel pipe for water loading. Connect it to a proper water inlet with
3/8F gas coupling adequately tightening the nut, then give network pressure. In this regard, it is necessary
to remember that, to operate correctly, the machine needs a minimum network pressure of 1.0 bars and
maximum pressure of 2.5 bars. It is important that the network pressure NEVER exceeds 2.5 bars!
WE RECOMMEND THE USE OF A WATER SOFTENER FILTER OR ANTI-SCALE BAG that must be
periodically replaced. If this is not done, scale deposits may form inside the machine, these can prejudice
the correct operation of the machine, apart from the validity of the warranty.
If the water freezes inside the machine circuit, remove the plug from the power socket, turn off the
machine and position it in a heated room with temperature not below 15°C. Wait about 30 minutes before
restarting and reusing the machine. To prevent freezing of the machine, and to have general optimum
operation, we recommend the use of the same in a room with temperature not below 15°C.
The power voltage of the machine is not modifiable by the user. Before
connecting it to the electric network, check that the voltage of the network
corresponds to the power supply voltage of the machine indicated on the
identification plate.