Starting and Stopping
•
THERE ARE 2 CUTTING HEIGHTS (E & F)
•
Height of cut is adjusted by turning over the
cutting head.
•
Disconnect from the mains electricity supply and
wait until the cutting head has stopped rotating.
Turn your product upside down.
•
To Remove the Cutting Head and Fan (G)
Hold the fan firmly and twist the cutting head
anti-clockwise as illustrated. Hold the cutting
head in the centre and remove as illustrated
Hold fan in the centre and remove as illustrated
•
Inspect for damage and clean as necessary
before replacing the fan and the cutting head
•
To Refit the Fan and the Cutting Head (H)
Replace the fan as illustrated. Replace the cut-
ting head, adjusting the height of cut as
required. Hold the fan firmly and twist the cut-
ting head clockwise, as illustrated.
•
IMPORTANT
ENSURE FAN AND CUTTING HEAD ARE
CORRECTLY LOCATED
D
Starting
1. Hold as illustrated in
Fig D
.
2. To start, press the lock-off button down, whilst
pressing the lock-off button, squeeze the switch
lever.
Stopping
1. To stop your product, release the switch lever.
G
H
1
2
3
3
2
1
Adjusting the Cutting Height
HIGHEST
This symbol visible
LOWEST
This symbol visible
Lock-off button
Switch lever
E
F
1. Start cutting the edge of the lawn nearest to the power point so that the cable is laid out on the lawn you have already cut.
2. Cut twice a week in the growing season, your lawn will suffer if more than one third of its length is cut at one time.
Do not Overload your Product
Cutting long thick grass may cause the motor speed to drop, you will hear a change in the motor sound. If the
motor speed drops you may overload your product which may cause damage. When using in long thick grass, a
first cut with the cutting height set higher will help reduce the load. See Adjusting the Cutting Height.
How to Use
