Shaft Assembly (A)
1. Locate the lower shaft (A1) into the upper shaft (A2).
2. Grasp firmly and hold steady the lower shaft. Lo-
cate the upper shaft and snap together firmly.
• The unit is correctly assembled when the gap be-
tween the upper and lower shaft has been closed.
Safety Guard Assembly (B) & (C)
1. Locate the safety guard (B1) over the cutting head
(B2). Ensure the nylon line is fed through the hole
in the safety guard as illustrated in fig B.
2. Push into location and turn safety guard in the di-
rection illustrated in Fig C, until a click is heard and
the safety guard is securely locked in position.
• ENSURE THE SAFETY GUARD IS SECURELY IN
PLACE BY ATTEMPTING TO TWIST GUARD.
Cable Restraint (D1) & (D2)
1. Form loop in mains cable and push the loop
through the slot as illustrated in picture (D1).
2. To secure, position loop over the hook and pull the cable
back through the slot as illustrated in picture (D2).
Assembly Instructions
A
1
2
1
2
B
2
1
C
D1
D2
Starting and Stopping
E
WARNING
Cutting head continues to rotate after the trimmer
has been switched off.
To start your trimmer
Squeeze the switch lever (E).
To stop your trimmer
Release the switch lever (E).
How to Trim
WARNING: The use of eye protection is recom-
mended. Do not lean over the trimmer guard whilst
trimming, objects may be thrown by the cutting line.
Do not allow cutting head to rest on the ground. Do
not overload your trimmer. Overloading can be
avoided by making sure the motor speed does not
drop unduly. Disconnect the mains electricity sup-
ply before attempting any maintenance or adjust-
ment.
1. Cut with cutting line at an angle using the tip
(F).
2. Swing trimmer in and out of the cutting area
taking small cuts (F).
F
