4
g
2 - Mower Trimming
For normal trimming, swing the head from side to side without tilting the string head. Keep the string
head at same level for an even finish.
3 - Close Trimming
Tilt the stringhead to the left for close trimming. Using the left side of the stringhead will also tend to
eject the grass or debris away from the operator.
4 - Scalping
The further the stringhead is tilted, the closer the cut. Take extra care for flying debris when doing this.
WARNING:
Only cut with the tip of the line. This is the most effective way to cut.
Take special care not to allow line to curl around mesh fencing or to rub hard against abrasive surfaces
such as walls. This will cause excessive line wear or line breakage.
5 - Bump feed
The lenght of the nylon line wears down naturally as you work. When this happens, tap the head on the
ground while it is turning. A further length of line will automatically be fed out. The knife integrated in the
plastic guard then ensures the line is cut to the optimum length. (Too much line reduces engine speed
and cutting performance).
ALWAYS USE GENUINE ACCESSORIES AND SPARE PARTS AVAILABLE FROM AUTHORISED
SERVICING DEALERS. THE USE OF NON-ORIGINAL ACCESSORIES AND SPARE PARTS
INCREASES THE RISK OF ACCIDENTS AND IN SUCH A CASE THE COMPANY IS NOT LIABLE
FOR DAMAGE TO PEOPLE AND/OR THINGS.
Y
ROUTINE MAINTENANCE
After usage, disconnect from the mains supply and clean dirt and debris from the cutter line area.
This will prolong motor life by maintaining adequate airflow to cool the motor and ensures the line head
continues to snap on and off smoothly.
Inspect the cutter line head for parts that may be chipped, cracked or damaged as these could fly away
and cause serious injury.
Replace damaged parts immediately. Use only genuine replacement parts. Any other maintenance work
should be carried out by an authorised Service Agent only. Check the product and cable regularly for
visible signs of damage or wear. Check that all fasteners and moving parts are secure. Consult an
Authorised Service Dealer if in doubt.
FAULT FINDING
If your trimmer will not start, check that all cables are connected and that the mains power is on. If it still
does not work, check the fuse. If you have tried the above and your trimmer still does not work, take it
to your nearest Authorised Service Dealer.
_
UNWANTED PRODUCTS AND THE ENVIRONMENT
Should you find one day that your product needs replacement, or is of no further use to you,
think of the protection of the environment. Service Centres will accept your old products and
will dispose of them in an environmentally safe way.
