Electrical
1.
The British Standards Institute recommend the use of a
Residual Current Device (R.C.D.) with a tripping current
of not more than 30mA. Even with a R.C.D. installed
100% safety cannot be guaranteed and safe working
practice must be followed at all times. Check your
R.C.D. every time you use it.
2.
Before use, examine cable for damage, replace it if
there are signs of damage or ageing.
3.
Do not use the lawnmower if the electric cables are
damaged or worn
4.
Immediately disconnect from the mains electricity
supply if the cable is cut, or the insulation is
damaged. Do not touch the electric cable until the
electrical supply has been disconnected. Do not
repair a cut or damaged cable. Replace it with a new
one.
5.
Your extension cable must be uncoiled, coiled cables can
overheat and reduce the efficiency of your mower.
6. Keep cable away from lawnmower, always work away
from the power point mowing up and down, never in circles.
7.
Do not pull cable around sharp objects.
8.
Always switch off at the mains before disconnecting any
plug, cable connector or extension cable.
9.
Switch off, remove plug from mains and examine electric
supply cable for damage or ageing before winding cable
for storage. Do not repair a damaged cable, replace it
with a new one. Use only Flymo replacement cable.
10. Always wind cable carefully, avoiding kinking.
11. Never carry the product by the cable.
12. Never pull on the cable to disconnect any of the plugs.
13. Use only on AC mains supply voltage shown on the
product rating label.
14. Our products are double insulated to EN60335.
Under no circumstance should an earth be
connected to any part of the product.
Preparation
1.
While using your product, always wear substantial
footwear and long trousers.
2.
Make sure the lawn is clear of sticks, stones, bones, wire
and debris; they could be thrown by the blade.
3.
Before using the machine and after any impact, check
for signs of wear or damage and repair as necessary.
4.
Replace worn or damaged blades together with their
fixings in sets to preserve balance.
Use
1.
Use the lawnmower only in daylight or good artificial light.
2.
Avoid operating your lawnmower in wet grass, where
feasible.
3.
Take care in wet grass, you may lose your footing.
4.
On slopes, be extra careful of your footing and wear
non-slip footwear.
5.
Mow across the face of slopes, never up and down.
6.
Exercise extreme caution when changing direction
on slopes. Walk never run.
7.
Mowing on banks and slopes can be dangerous. Do
not mow on banks or steep slopes.
8.
Do not walk backwards when mowing, you could trip.
9.
Never cut grass by pulling the mower towards you.
10. Switch off before pushing the mower over surfaces
other than grass.
11. Never operate the lawnmower with damaged guards
or without guards in place.
12. Keep hands and feet away from the blade at all times
and especially when switching on the motor.
13. Do not tilt lawnmower when the motor is running,
except when starting and stopping. In this case, do
not tilt more than absolutely necessary and lift only
the part which is away from the operator. Always
ensure that both hands are in the operating position
before returning the appliance to the ground.
14. Never pick up or carry a mower when it is operating
or still connected to the mains supply.
15. Remove the plug from the mains :
-
before leaving the mower unattended for any period;
-
before clearing a blockage;
-
before checking, cleaning or working on the appliance;
-
if you hit an object. Do not use your lawnmower until
you are sure that the entire lawnmower is in a safe
operating condition;
-
if the lawnmower starts to vibrate abnormally. Check
immediately. Excessive vibration can cause injury.
Maintenance and storage
1.
Caution: Do not touch rotating blade.
2.
Keep all nuts, bolts and screws tight to be sure the
lawnmower is in safe working condition.
3.
Check the grassbox frequently for wear or
deterioration.
4.
Replace worn or damaged parts for safety.
5.
Only use the replacement blade, blade bolt, spacer
and impeller specified for this product.
6.
Be careful during adjustment of the lawnmower to
prevent entrapment of the fingers between moving
blades and fixed parts of the machine.
7.
Store in a cool dry place and out of reach of
children. Do not store outdoors
8.
Allow the product to cool for at least 30 minutes
before storing.
CABLES - IMPORTANT
•
Use only 1.00mm
2
size cable up to 40 metres length
maximum.
Maximum rating :
1.00mm
2
size cable, 10 amps 250 volts AC.
•
YOUR PRODUCT IS SUPPLIED WITH AN
ELECTRIC
MAINS CABLE FITTED WITH A FEMALE
CONNECTOR.
1. Flymo Mains Cables and Extension Cables are available
from your local Approved Service Centre.
2. Do not wire an extension cable directly to your product
yourself. Please contact your local Approved Service
Centre for further information on the connectors and
kits available.
3. Only use extension cables specifically designed for
outdoor use.
CONNECTORS - IMPORTANT
•
Flymo connectors are suitable for use with 2 core
cable only. Under no circumstances should these
connectors be used for earthed products.
•
All Flymo connectors and cables are of splashproof
construction. They are not waterproof and must not
be left outside permanently nor should they be
submerged or immersed in water. Do not let cable lay
or trail through pools of water or splashed with water
from hose pipes.
MAINS PLUG REPLACEMENT - IMPORTANT
•
If the plug supplied is cut off it should be destroyed.
There is an electric shock hazard if a cut off plug is
inserted into a 13 amp socket.
1. No earth required. Flymo products are double
insulated to EN60335 and under no circumstances
should an earth be connected to any part of the
product.
2. Ensure the mains voltage suits your product
3. IMPORTANT!
The wires in the mains lead are coloured in
accordance with the following code:
BLUE - NEUTRAL
BROWN - LIVE
The wire which is coloured BLUE must be connected
to the Terminal which is marked with the letter 'N' or
coloured BLACK.
The wire which is coloured BROWN must be
connected to the Terminal which is marked with the
letter 'L' or coloured RED.
4. It is important that the outer sheath is clamped
correctly into the 3-pin plug.
5. If in doubt consult your local Service Repairer or
qualified electrician before the machine is used.
6. A 13 Amp fuse must be fitted to the Mains Plug.
7. The normal plug fuse and household fuse only protect
the electrical equipment and are not a safeguard
against electrocution.
Cables
