Flymo EasiSaw 350E, Руководство оператора

Страница: 14 / 28

• If you do not do maintenance, it decreases the
life cycle of the product and increases the risk of
accidents.
• Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual
are approved after you have done maintenance, turn
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
• Only use original spare parts.
Safety instructions for the cutting equipment
WARNING:
Read the warning
instructions that follow before you use the
product.
• Only use approved guide bar/saw chain
combinations and filing equipment. Refer to
Technical data on page 24
for instructions.
• Use protective gloves when you use or do
maintenance on the saw chain. A saw chain that
does not move can also cause injuries.
• Keep the cutting teeth correctly sharpened. Obey the
instructions and use the recommended file gauge. A
saw chain that is damaged or incorrectly sharpened
increases the risk of accidents.
(Fig. 39)
• Keep the correct depth gauge setting. Obey the
instructions and use the recommended depth gauge
setting. Too large depth gauge setting increases the
risk of kickback.
(Fig. 40)
• Make sure that the saw chain has the correct
tension. If the saw chain is not tight against the guide
bar, the saw chain can derail. An incorrect saw chain
tension increases wear on the guide bar, saw chain
and chain drive sprocket. Refer to
Accessories on
page 25 .
(Fig. 41)
• Do maintenance on the cutting equipment regularly
and keep it correctly lubricated. If the saw chain is
not correctly lubricated, the risk of wear on the guide
bar, saw chain and chain drive sprocket increases.
(Fig. 42)
Assembly
To assemble the guide bar and saw
chain
WARNING:
Always disconnect the
power plug from the power source before
you assemble or do maintenance on the
product.
1. Disengage the chain brake. (Fig. 43)
2. Loosen the bar knob and remove the drive sprocket
cover and the transportation guard (A). (Fig. 44)
3. Put the guide bar on top of the bar bolt. Steer the
guide bar to its most rear position. Lift the saw chain
above the drive sprocket and engage it in the groove
on the guide bar. Start on the top edge of the guide
bar.
4. Make sure that the edges of the cutters point forward
on the top edge of the guide bar. (Fig. 45)
5. Install the drive sprocket cover and steer the chain
adjuster pin to the hole in the guide bar.
6. Make sure that the drive links of the saw chain fit
correctly on the drive sprocket.
7. Make sure that the saw chain is correctly engaged in
the groove in the guide bar.
8. Apply tension to the saw chain. Refer to To adjust
the tension of the saw chain on page 22
for
instructions.
9. Tighten the bar knob.
Operation
Introduction
WARNING:
Read and understand the
safety chapter before you use the product.
To do a function check before you use
the product
1. Do a check of the front hand guard (A) to make sure
that it operates correctly and is not damaged. (Fig.
46)
2. Do a check of the rear hand guard (B) to make sure
that it is not damaged.
3. Do a check of the power trigger (C) and the power
trigger lockout (D) to make sure that they operate
correctly and that they are not damaged.
14 1810 - 001 -