11. Do not attempt to repair the unit including the battery.
Nylon line replacement and cleaning the unit are the
only items suitable for user maintenance.
12. Do not insert any object into the motor area.
Keep free of debris to avoid overheating.
13. Do not incinerate or mutilate the battery. Batteries
contain hazardous chemicals. Dispose of properly.
Preparation
1. While using your product always wear substan-
tial footwear and long trousers.
2. Before using the machine and after any impact, check
for signs of wear or damage and repair as necessary.
3. Inspect the area to be cut before each use.
Remove all objects such as stones, broken glass,
nails, wire, string etc, which can be thrown or
become entangled in the trimmer head.
4. Check that the cutting head, spool and cap are
fitted correctly.
Use
1. Use the trimmer only in daylight or good artificial light.
2. Avoid operating your trimmer in wet grass,
where feasible.
3. Take care in wet grass, you may lose your footing.
4. On slopes, be extra careful of your footing and
wear non-slip footwear.
5. Do not walk backwards when trimming, you
could trip. Walk, never run.
6. Never operate the trimmer with damaged guards
or without guards in place.
7. Never fit metal cutting elements.
8. Keep hands and feet away from the cutting means at
all times and especially when switching on the motor.
9. Keep cutting head below waist level.
10. Do not lean over the trimmer guard whilst trimming or
edging - objects may be thrown by the cutting line.
11. Beware of cut-off pieces of nylon line ejected
during use.
12. If you hit an object, do not use your trimmer until
you are sure that the entire trimmer is in a safe
operating condition.
13. If the trimmer starts to vibrate abnormally, check
immediately. Excessive vibration can cause injury.
Maintenance and storage
1. Keep all nuts, bolts and screws tight to be sure
the trimmer is in safe working condition.
2. Replace worn or damaged parts for safety.
3. Only use the replacement cutting line specified
for this product.
4. Only use replacement parts and accessories
recommended by Husqvarna Outdoor Products.
5. To avoid the risk of injury keep fingers and hands clear
of the line cutter on the leading edge of the guard.
6. Clean unit with a dry cloth. Never use metal
objects to clean the unit.
7. Inspect and maintain the trimmer regularly. Any
repairs must be carried out by an authorised repairer.
Battery Care
1. If over a period of time the battery quickly runs
down after a full 24 hour charging period, a
replacement battery is needed.
2. There will be some charge present in the battery
but to ensure maximum running time, recharge
your trimmer for 24 hours before use.
3. Permanent connection to the charger in a well
ventilated area will automatically keep your bat-
tery fully charged ready for use.
4. To prevent permanent battery damage, never
store in a discharged condition.
5. Contact your local approved service centre/deal-
er/distributor for a replacement battery and for
safe disposal of your old battery.
6.
Battery
12 Volt 7 Amp/Hour "High Power"
Sealed for Life
No maintenance required
• IMPORTANT
DISPOSE OF YOUR OLD BATTERIES SAFELY
DO NOT CUT OPEN, BURN OR INCINERATE.
Battery Replacement
Should your battery need to be replaced contact your local
approved service centre or dealer who will remove your old
battery and fit a genuine Flymo replacement battery.
IMPORTANT
The red lead should always be connected to the red
terminal on the battery. The black lead should always
be connected to the black terminal on the battery.
Bench Top Re-charging
The wall bracket can also be used as a "bench top"
stand for re-charging your cordless trimmer.
Winter Storage
1. Fully charge for 24 hours before winter storage.
2. If you are unable to leave your cordless trimmer on
permanent charge, re-charge the battery every 3 to
4 months for a full 24 hour charging period to top up
the battery charge during winter storage.
3. Avoid extended storage without re-charge.
4. Store in a cool dry place.
For further information on Battery replacement
contact Husqvarna Outdoor Products Customer
Service direct:-
Telephone:
0870 609 1901
Fax:
0870 609 1901
Battery
Assembly Instructions
Assembly of Switch Handle to Tube (A1)
• Ensure that the internal cable is not twisted.
1. Insert the tube into the switch handle.
2. Push until it clicks into position.
• ENSURE THAT THE TUBE IS FULLY LOCATED
BY ATTEMPTING TO REMOVE IT.
Assembly of Trimmer Head to Tube (A2)
• Ensure that the internal cable is not twisted.
1. Insert the tube into the trimmer head.
2. Push until it clicks into position.
• ENSURE THAT THE TUBE IS FULLY LOCATED
BY ATTEMPTING TO REMOVE IT.
A1
A2
