flyingwings Hornet Mini FPV Racer, Руководство пользователя

Страница: 6 / 10

Installing the horns & pushrods.
SWITCH ON YOUR RADIO AND CANCEL ALL SUB TRIM
SET TRIMS TO NEUTRAL
Screw the screws into the horns so that the points of the
screws are just proud, Line up the horns as shown in FIG
5C, press down the horns, then screw them right down, get
the bottom part of the horn, align screws and screw down
until the horns grip the elevon, but not too tight.
Screw the clevises onto the pushrods halfway, attach the
clevis to the servo horn, Set the elevon position slightly
upwards as shown, mark the pushrod with a felt tip and
make your z-bend at this point. Note the horn holes may
need to be enlarged slightly,
Use a ruler to set neutral position
STEP
8
Attach wing tips with glue
Push rod assembly:
Glue the plastic clevises onto the end of each carbon push rod,
with CA glue. Attach the piano wire a 20mm overlap to the carbon
rod. Use a generous blob of CA glue to coat this area. Slide the
heatshrink tube over and shrink using a heat source.
30mm
40mm
CA Glue
Heatshrink
Wire
STEP
7