8
The purpose of the counter weight system is to match the low end of the stabilizer to the weight
of the camera and accessories at the high/top end with the gimbaled handle as the pivot point in
between.
The heavier the camera and accessories, the more weights are required to achieve proper
balance. Generally as you add weight to one side of the central post, an equal amount has to be
added to the other side to maintain horizontal balance.
However if you are using an offset configuration such as a flip out viewfinder or off center
accessories, extra weights might be needed on the opposite side of the post to counter act and
maintain proper balance.
Total weight fixed to the base platform should be equal to the weight of your camera plus the
head and any accessories.
Vertical Adjustment
of telescopic
central post is made by loosening the
control located at the base, raising or
lowering the post to desired location
and then retightening the vertical
control. Do not over-tighten this
control.
Balancing your Flycam Stabilizer
Before beginning the balancing process check the following:
Camera is securely attached to Head Plate
Lens cap is removed and secured
Telescoping Clamp is tightened
Weight discs are added successfully
All screws are tightened securely
Battery, all accessories and cables are secured
