4
–
ELIOS 2 GOV Controller
ELIOS 2 GOV USER MANUAL
Page 8 of 13
Calibration
The calibration process will redifine the centre position and travel range of the input sticks and the camera
tilt lever. Controllers are calibrated during production, and recalibration should never be necessary.
To calibrate, press the POWER and AUX buttons simulaneously for 5 seconds to enter the calibration mode.
The status LED will turn blue. The three right battery level LEDs each represent one controller input, and will
flash if they are off center:
–
The right LED represents the right control stick
–
The LED second from right represents the left control stick
–
The LED third from right represents the camera tilt knob
Move all inputs through their entire range of motion, and leave them centered for 5 seconds. The Leftmost
battery level LED will blink for 3 seconds, indicating that the inputs are now calibrated. Turn off the
controller to save the new calibration.
Pairing
Every drone is paired to its own GCS controller, if you wish to pair a drone to another GCS controller then you
must first follow this procedure. The pairing procedure will link a specific controller to a specific drone. Once
a controller and a drone are paired, they will remain paired with each other until either one is re-paired to
another unit.
The pairing procedure:
1.
On the GCS, go to the pairing menu tab in the cockpit app and press
start.
2.
On the drone, press the pairing button for about. 7 seconds.
The pairing button is located next to the status LEDs, it is covered by a T6 screw which needs to be removed
first. The button must be pressed using the Sim card remover tool provided in the Tool kit (or with a paperclip).