EN
GLISH
9
FLUVAL FILTER & HEATER INSTALLATION, USE AND MAINTENANCE
Please refer to the instruction manual of the Fluval filter/heater. Do not attempt to set up the Fluval filter/heater without reading
and following the instruction manual. If it is missing or unusable, contact the store or Hagen Customer Service.
LED STRIP LIGHT INSTALLATION INSTRUCTIONS
WARNING: Disconnect the plug of all electrical equipment used for the aquarium, before placing your hands in
aquarium water and/or performing any maintenance of any kind.
Initial start-up
1. Carefully place the LED Strip Light (C) on the runner of the top frame in the final position (Pict. 11).
2. Pull the LED Strip cable out through the cross of the rim cable guide (as indicated above).
3. Hook up the lighting unit to the LED driver with its connector (Pict.12).
WARNING: Do not plug in the LED Strip Light if there is water on parts not intended to be wet.
Switching the LED Strip Light On
Plug in the unit and use a smartphone or tablet with the
FluvalSmart app downloaded to connect to it.
The FluvalSmart App can be downloaded from the iOS or Android
App stores, or scan the QR code to download.
Use exclusively the LED driver supplied with the LED Strip Light.
In all cases, make sure that the LED driver specifications comply
to the specifications indicated in the LED Strip Light identification
codes table below.
FLUVAL SHAKER LED STRIP LIGHT SPECIFICATIONS
Aquarium Model
168L SHAKER
252L SHAKER
LED STRIP LIGHT UNIT
BT LED UNIT SHAKER
BT LED UNIT SHAKER
LED STRIP LIGHT MODEL NUMBER
A13246
A13247
LUMINAIRE WATTAGE
16.5 W
24 W
LUMENS
1300lm
1950lm
LUMINAIRE OPERATING VOLTAGE
24Vdc
24Vdc
LED DRIVER TYPE
S018BA[X] 2400063
S024AM[X] 2400100
LED DRIVER INPUT VOLTAGE
100-240 Vac
100-240 Vac
X = B For UK Plug
X = V For EU Plug
X = U For US Plug
X = S For AUS Plug