EN-10
7. Move the filter canister to its final position.
8. Be certain the purge valve is in the vertical
(closed) position.
9. Pour about 2 gallons (8 liters) of water into the
filter canister.
IMPORTANT:
Correct water volume is necessary
for system priming.
10. Place the filter lid back on the canister.
Check to
make sure the filter lid seal ring is present and
installed properly on the canister lid. There is
only one orientation possible. Gently press the
lid down until the output tube is firmly seated in
the OUT connection on the filter lid.
Important:
If the inlet tube attached to the
canister lid has slipped out of its seat, be sure to
fully re-insert it under the IN connection of the lid.
11. Replace and hand-tighten the eight lid fasteners.
The lid is properly closed when it is in direct
contact with the canister.
DO NOT USE ANY
TOOLS, AS DOING SO MAY DAMAGE THE UNIT.
INSTALLATION AND USE
