Blinking a Port Light
51
Blinking a Port Light
The
Blink Port Light
function helps you determine which
cable is connected to which port on a network hub or
switch. This function generates a link pulse on pairs 12
and 36 to blink the port’s activity LED.
The tester’s analog toner is also active when the port
light function is active.
To blink a port light:
1
Turn the rotary switch to
DIAG
.
2
Connect the tester to the cabling as shown in
Figure 22.
3
Use
D
to highlight
Blink Port Light
; then press
H
,
J
, or
P
.
To change the blink rate, press
K
.
4
Check the hub or switch to see which activity LED is
blinking. The tester’s analog toner is on, so you can
also use a tone probe to locate the cable if necessary.
Note
The
Blink Port Light
function does not work
with non-negotiating hubs or with ports that
use signal timing outside of typical timing
parameters.
avv05f.eps
Figure 22. Blinking a Port Light
Содержание CableIQ
