3210-PR-TF English Instruction Sheet
Page
3
•
Comply with local and national safety codes. Use
personal protective equipment (approved rubber gloves,
face protection, and flame-resistant clothes) to prevent
shock and arc blast injury where hazardous live
conductors are exposed.
•
Do not work alone.
•
Limit operation to the specified measurement category,
voltage, or amperage ratings.
•
De-energize the circuit or wear personal protective
equipment in compliance with local requirements before
you apply or remove the Flexible Current Probe.
•
Do not touch voltages > 30 V ac rms, 42 V ac peak, or
60 V dc.
•
Equipment is to be used in 600 V CAT IV and 1000 V
CAT III environments.
•
Do not use the Product around explosive gas, vapor, or in
damp or wet environments.
Operating Instructions
1.
Connect the Probe to the 1750 via the 1750 current input jack.
2.
Wear protective equipment or de-energize the circuit and place
the Probe around the conductor under test. To lock the coil,
see Figure 1.
3. Re-energize
the
circuit.
4.
Observe and take measurements as required. Positive output
indicates that the current flow is in the direction shown by the
arrow on the Probe.
5.
Wear protective gloves or de-energize the circuit before
removal of the Probe.
fig1.eps
Figure 1. Locking the Coil
Maintenance
Clean the Probe periodically by wiping it with a damp cloth and detergent.
Do not use abrasive cleaners or solvents. Do not immerse the Probe in
liquids.
1.800.561.8187
Fluke-Direct
.ca
