Fluke Calibration 5522A, Начало работы

Страница: 12 / 42

5522A
Getting Started
2
•
Programmable entry limits which prevent the operator from entering values that
could cause damage to the connected instrument.
•
Simultaneous output of voltage and current, up to an equivalent of 20.91 kW.
•
Pressure measurement when used with Fluke 700 Series pressure modules.
•
10 MHz reference input and output. Use this to input a high-accuracy 10 MHz
reference to transfer the frequency accuracy to the 5522A, or to synchronize one or
more additional 5522A Calibrators to a master 5522A.
•
Simultaneous output of two voltages.
•
Extended bandwidth mode outputs multiple waveforms down to 0.01 Hz, and sine
waves to 2 MHz.
•
Variable phase signal output.
•
Standard IEEE-488 (GPIB) interface, complying with ANSI/IEEE Standards
488.1-1987 and 488.2-1987.
•
EIA Standard RS-232 serial data interface for printing, displaying, or transferring
internally stored calibration constants, and for remote control of the 5522A.
•
Pass-through RS-232 serial data interface for communicating with the Unit Under
Test (UUT).
Safety Information
This Calibrator complies with:
•
ANSI/ISA-61010-1 (82.02.01)
•
CAN/CSA C22.2 No. 61010-1-04
•
ANSI/UL 61010-1:2004
•
EN 61010-1:2001
In this manual, a Warning identifies conditions and actions that pose hazards to the user.
A Caution identifies conditions and actions that may damage the Calibrator or the
equipment under test.
Symbols used in this manual and on the Product are explained in Table 1.
Table 1. Symbols
Symbol Description Symbol Description
CAT I
IEC Measurement Category I – CAT I
is for measurements not directly
connected to mains. Maximum
transient Overvoltage is as specified
by terminal markings.
)
Conforms to relevant North American
Safety Standards.
P
Conforms to European Union
directives
~
Do not dispose of this product as unsorted
municipal waste. Go to Fluke’s website for
recycling information.
W
Risk of Danger. Important information.
See manual.
X
Hazardous voltage
J
Earth ground
;
Conforms to relevant Australian EMC
requirements