Fluke Calibration 4322-SYS-NAVAIR, Руководство по обслуживанию

Страница: 124 / 186

4322
Service Manual
5-30
Pressure Gauge
Use the following instructions and Figures 5-7 and 5-13 to replace the pressure gauge
(

).
1. Remove the chassis and separate the chassis. See “Chassis” on page 5-11.
Note
Depending on the previous level of disassembly the control panel assembly
screws may not be fully removed as the spacers help captivate the screws.
The screws must be fully removed to remove the support bracket (

). Hold
the spacer tube to prevent it from spinning while removing the screws.
2. Put the control panel (

) on a flat work surface upside down, using support blocks
to keep it raised above the surface
3. As shown in Figure 5-7, remove the four screws (

) that secures the support
bracket (

) to the control panel assembly (

) and handles (

).
4. As shown in Figure 5-7, remove the support bracket (

).
5. Disconnect the pressure supply connection (

) to the HF2-1/4 NPT adapter (

).
6. Remove the HF2-1/4 NPT adapter (

) from the pressure gauge (

).
7. Remove the pressure gauge (

) from the control panel (

).
8. Put the new pressure gauge (

) in the control panel (

).
9. Apply PTFE tape to the NPT threads on the pressure gauge (

).
10. Install the HF2-1/4 NPT adapter (

) on the pressure gauge (

).
11. Connect the pressure supply connection (

) to the HF2-1/4 NPT adapter (

).
12. As shown in Figure 5-7, install the support bracket (

) on the control panel
assembly (

) with four screws (

) and two lock washers (

).
13. Put the chassis together and put into the case. See “Chassis” on page 5-11.
2
3
4
1
hbx021.eps
Figure 5-13. Pressure Gauge Replacement