Fluid BID1000W, Инструкция по эксплуатации

Страница: 4 / 20

Important Safety Instructions
CAUTION –
Failure to follow the instructions may cause body injury or property damage.
Grounding Instructions
DANGER –
Improper use of the grounding plug can result in a risk of electric shock.
SAVE THESE INSTRUCTIONS
If repair or replacement of the cord or plug is necessary, do not connect the grounding wire to either flat
blade terminal. The wire with insulation having an outer surface that is green with or without yellow
stripes is the grounding wire. This product is factory equipped with a specific electric cord and plug to
permit connection to a proper electric circuit. Make sure that the product is connected to an outlet
having the same configuration as the plug. No adapter should be used with this product. Do not modify
the plug provided — if it will not fit the outlet, have the proper outlet installed by a qualified electrician.
If the product must be reconnected for use on a different type of electric circuit, the reconnection
should be made by qualified service personnel.
This product should be grounded. In the event of an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric current. This product is equipped with a cord
having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly
installed and grounded.
1.
Do not install or use the product in wet places as steam room etc.
2. It is recommended to use water-proof electrical outlet which should be lnstalled in the place where is not
easily got wet.
3. This product should be used with 110V-120V,50/60Hz electrical current only, load current is at least 15A.
Power plug must be equipped with ground fault circuit interrupter or ground fault electrical leakage protector
or similar high sensitive, rapid type leakage switch (Rated sensitive current under 6mA).
4.
When it thunders,it is strongly recommended to pull out the power plug.
5. Do not stand on ceramic toilet.
6.
Ceramic toilet must install floor fixing bolt.
7. Do not stand on product unit,seat and cover.
8.
Do not lean against the seat cover when using the product,to avoid damage.
9. This product is equipped with soft-closing seal cover.Heavy pressing or pushing may damage the
soft-closing damper.
10. Do not use lacquer thinner,petrol,liquid medicine,detergent,insecticide,toilet cleanser and scrubbing brush
to clean the product.
11. Exposure to direct sunlight is prohibited.
12.
Only use tap water or potable water;otherwise it may cause chafing.
13. Do not connect water supply to heater outlet.Make sure inlet water temperature at 3~35
℃
/ 37.4~95 F
14.
When the room temperature is under zero degree,please dry up the water tank,to avoid freezing.
15. Raise rest room temperature to prevent the toilet from damage due to freezing.
16.
When move the product from cold or wet environment into normal room temperature,wait for 2 hours until
the condensation water is fully volatilized.Doing so can prevent the product from electrical short-circuit.
17.
When not using the product over three(3) days,drain the water out of the container and pull the electrical
plug from the wall outlet.
18.
Stop using the product and shut off the power when product malfunctions,please contact the service
people for professional service.