|
6
QS300820 Rev A2
CONFIGURING ECHOTOUCH
®
(DISPLAY) –
US06 SERIES ONLY
TOP-LEVEL MENU
The transmitter is configured with the three buttons on the transmitter face (
UP
,
DOWN
and
OK
) and the
transmitter’s LCD. To access the transmitter’s Top-level menu, simply hold down the OK button for five
seconds. The display menu will automatically begin to scroll through the TOP-LEVEL MENU.
When the menu scrolls to an item you wish to configure, simply press the OK button to choose that item. The
TOP-LEVEL MENU will continue to scroll through the following (
UNITS – TANK – dISPLY – OUTPUT –
VALUES – RUN
), If you miss your selection, it will appear again shortly.
To return to the TOP-LEVEL MENU, press OK when
EXIT
appears.
To return to Operational Mode of the transmitter, press OK when
RUN
appears in the TOP-LEVEL
MENU.
Note:
To speed up the scrolling of the values on the display, hold down the OK button while holding
down the UP or DOWN buttons.
STEP 1 - MEASURE THE TANK
Measuring the tank is one of the most important aspects in
configuring the transmitter. When measuring the tank, take into
account the location of the transmitter with respect to fittings,
risers, dome tops and bottoms, and identify where the
measurements are taken from the transmitter. The HEIGHT
(4mA) and FILL-H (20mA) settings determine the 4-20mA span
and are always measured from the bottom of the tank up.
Height:
Sets the location for 4mA. It is based on the distance
from the Empty level position (bottom of tank) to the
Measurement location for the sensor (bottom of sensor).
Fill-Height:
Sets the location for 20mA. It is based on the
distance from the Empty level position (bottom of tank) to the Full
level position (see below).
#2 - SETTING THE UNITS OF MEASUREMENT (UNITS)
The EchoTouch
®
displays information in the following units:
inches, feet, centimeters, meters or percentage. The value
shown on the display represents the amount of liquid in the
tank.
1) In TOP-LEVEL MENU mode, select
UNITS
by pressing OK.
2) Next, select
INCHES, FEET, CM, METERS
by pressing
OK.
3) Finally, select
EXIT
by pressing OK to return to the TOP-
LEVEL MENU.