Flower House SpringHouse, Настройка

Страница: 2 / 5

Self-erecting portable greenhouses Set up Instructions
Page 1
Step 1:
Remove
your SpringHouse™
from the pack.
Step 2:
Allow your
SpringHouse™ to spring open.
Step 3:
Unfold your
SpringHouse™ into 2 panels.
Step 4:
Unzip the easiest
accessible doorway and screen.
Grab the center steel band and
lift up to separate the two sides
of your SpringHouse™.
Step 5:
Stand on the bottom
corner of the skirting and lift
your SpringHouse™ over your
head. Push out on the center
steel band (Shown in fig. D) and
left up to separate the two sides
of your SpringHouse™.
Step 6:
Stand pm the bottom
corner of the skirting and lift your
SpringHouse™ over your head.
Push out on the center steel band
(Shown in fig. D) and left up to
separate the two sides of your
SpringHouse™.
Step 7:
Secure your
SpringHouse™ using the
supplied stakes. Insert the
stakes into the stake holes
of the skirt at 45
°
angles.
Step 8:
You must secure your
SpringHouse™ using the High-wind tie-
downs. Insert one end of the rope through
the D-ring in the top corner, then through
the anchor. Knot the rope around a stake
and insert it in the ground at a 45
° angle.
Keep as much tension on the rope as
possible. Repeat this step with all corner
locations, as well as the D-rings on the peak
ends and top center of the side walls.