8
•
Unscrew the screws inside the device to be able to open the inspection
hatch.
•
Depending on the length of the device, the number of screws varies (see
the table)
Model
Number of screws to unscrew
inside
ELIS AX 100
3
ELIS AX 150
5
ELIS AX 200
5
ELIS AX 250
7
CAUTION
Hold the hatch while unscrewing to prevent it from opening suddenly.
Power supply conection position
Transformer position (optional)
Position of the DRV ELIS AX in the curtain
WARNING
1.
The power connection should be made in accordance with the technical documentation. The device
installation should always be carried out in accordance with applicable local safety standards.
2.
The cross-section and type of cable should be selected by the designer. (Always make sure that the
disconnectors and protective switches are properly sized and disconnect all poles of the power supply).
3.
Make sure that the connection of power supply and controllers to the ELiS AX curtain is made in accordance
with the electrical specifications and the instructions included in the connection diagrams in the technical
documentation.
4.
Before connecting the power supply, check that the mains voltage corresponds to the voltage on the
device's type plate.
5.
Check the power connection before connecting the air curtain.
6.
Starting the device without connecting the grounding wire is not allowed.
7.
Protect the power cord against pulling out by clamping the cable gland.
8.
Tighten all connection cables in the block properly
9.
Do not start the device with the service hatch open.
PIC. 7.3 RELEASING THE INSPECTION HATCH.
PIC. 7.4 VIEW OF CONNECTIONS AND DRV ELIS AX INSIDE THE INSPECTION HATCH
