Flott P 30 STG PV, Руководство по эксплуатации

Страница: 25 / 47

205289 D/GB
23
GB
à
Drilling with Programmable Feed
In accordance with the selected parameters, start the feed with the drilling crosshairs
tracer (30). If the drilling crosshair tracer is actuated again the feed stops. Once the selected drilling depth is attained,
the feed remains in this position (relief milling for 0.5 sec).
2.4 „Tapping“
Pole-changing switch at setting "0". Main switch to position "1". Sleeve in basic position "Top". Clamp the drilling
depth stop (24) at maximum drilling depth.
Use to select the mode of operation "Tapping" (key lights up).
In contrast to the operating modes "Drilling with manual feed" and "Drilling with programmable feed PV", the operating
mode "Tapping" can also be started when the sleeve is not in the basic position "Top". This function is required if, for
example, an operation has been terminated and the drill is still in active contact.
Attention! Spindle turns "Left" until the sleeve reaches the basic position "Top".
à
Spindle speed
Use pole-changing switch to select the speed step. While the machine is running, set the spindle speed with the
adjusting lever (19).
à
Reference point
Use the drilling crosshairs to guide the tool to the workpiece and to set the actual value for drilling depth to
zero.
à
Setpoint value for drilling depth
Use and to move the flashing cursor to the digit to be changed. Use or to change the value.
or
Set the reference point. Use the drilling crosshairs to guide the tool to the desired drilling depth. Press to
accept the displayed "Actual value for drilling depth" into the displayed "Setpoint value for drilling depth".
à
Tapping
In accordance with the parameters selected, the drill is guided down into the core hole by means of drilling crosshairs
until it starts cutting. The drill then automatically pulls itself into the core hole until the set thread depth has been
reached, the limit switch "Thread bottom" is actuated, or the drilling crosshair tracer (30) is actuated. At this stage the
electronic system changes the direction of rotation of the spindle and the drill automatically pulls itself out of the
thread hole it has created. The sleeve's retraction spring pulls the drilling spindle back into its original position. The
top limit switch is actuated at this position and the electronic system again reverses the direction of rotation.