FLORABEST FBKS 52 A1, Перевод оригинальной инструкции

Страница: 12 / 53

FBKS 52 A1
■ 8
│ GB │ IE │ NI
Before use
Mixing fuel
The engine must be operated with a mixture of petrol and motor oil.
WARNING!
► Avoid direct skin contact with fuel and inhaling fuel vapours.
■ Always use a mixture of unleaded petrol (at least RON 95) and special
2-stroke engine oil (JASO FD/ISO-L-EGD). Mix up the fuel mix accord-
ing to the fuel mixing table.
■ Pour the correct amount of petrol and 2-stroke oil into the supplied
mixing container (see "Fuel mix table").
Then shake the mixing container well.
Fuel mix table
Mixing process: 40 parts petrol to 1 part oil
Petrol 2-stroke oil
0.5 litres 12.5 ml
Adding fuel
WARNING!
► Fill the fuel tank only when the engine is switched off and cooled
down. There is a risk of fire!
♦ Always clean the area around the fuel tank cap before filling to
prevent dirt getting into the tank.
Use a dry, lint-free cloth to do this.
♦ Lay the appliance on its side so that the fuel tank cap is facing
upwards.
♦ Turn the fuel tank cap anticlockwise and remove it.
The fuel tank cap is connected to the fuel tank with an anti-loss
device and cannot fall down.
♦ Fill the tank with the fuel mix.
Do not spill any fuel while filling the tank and do not fill the tank to
overflowing.
♦ Wipe up any spilled fuel immediately.
♦ Turn the fuel tank cap clockwise to close it.
NOTE
► When filling the fuel tank, also check the chain oil.
Adding chain oil
WARNING!
► Fill the chain oil only when the engine is switched off and cooled
down. There is a risk of fire!
► Never work without chain lubrication!
If the saw chain runs dry, the cutting equipment may become irre-
parably damaged in a short time.
► Always check chain lubrication before starting work .
NOTE
► Use only saw chain oil. Preferably biodegradable. Do not use waste
oil, motor oil, etc.
► While working, check whether the chain lubrication is working
correctly.
♦ Always clean the area around the chain oil tank cap before filling
to prevent dirt getting into the chain oil tank.
Use a dry, lint-free cloth to do this.
♦ Lay the appliance on its side so that the chain oil tank cap is facing
upwards.
♦ Turn the chain oil tank cap anticlockwise and remove it.
The chain oil tank cap is connected to the chain oil tank with an
anti-loss device and cannot fall down.
♦ Add the supplied organic chain oil to the chain oil tank.
Do not spill any chain oil while filling the chain oil tank and do not fill
the tank to overflowing.
♦ Wipe up any spilt chain oil immediately.
♦ Turn the chain oil tank cap clockwise to close it.
Tightening and checking the saw chain
WARNING!
► Wear protective gloves! There is a danger of injury from the sharp
cutting teeth!
► Check the chain tensioning before every use.
♦ Before tensioning, slightly loosen both locking nuts using the spark
plug spanner .
♦ Turn the chain-tensioner screw in a clockwise direction using the
flat-blade screwdriver to increase the tension.
♦ Tighten the two locking nuts hand-tight using the spark plug
spanner .
♦ The saw chain must lie against the underside of the blade. Check
whether the saw chain (chain brake off, pull front hand guard
to the rear) can be drawn over the guide rail by hand.
NOTE
► A new saw chain stretches and must be tightened more regularly.