11
GB
note:
Keep 4 pieces of approx. 50 x 50 x 5 cm
paving slabs close at hand for the paving stand.
Place the paving slabs evenly on the cross members
of the paving stand.
Q
Assembling the paving stand
j
Fit the cross member for paving stand 2
2
on top
of the cross member for paving stand 1
1
(see
Figure B).
j
Bolt the bottom pole section
3
to the assembled
cross members. Use the bolts (approx. M8 x
20 mm)
4
with the plain washers
(approx. ø 8 mm)
5
(see Figure C).
j
Insert the top pole with attachments
6
into the
bottom pole section
3
attached to the paving
stand and screw the two poles together with the
union nut
13
(see Figure D, step
1
).
Q
Opening the umbrella top
j
Push the arm
7
upwards until it meets the stopper
18
(see Figure E, step
1
). Lock the support rod
16
in place by pushing the plastic sleeve
17
downwards (see Figure E, step
2
).
j
Push the handle
12
upwards until it meets the
stopper
10
(see Figure F, step
1
). Lock the handle
12
in place with the locking knob
11
. To do this
turn the locking knob
11
in the clockwise direction
to tighten it (see Figure F, step
2
).
j
Turn the crank
14
clockwise until the umbrella top
8
is completely open (see Figure G, step
1
).
Q
Turning the umbrella roof
j
Release the lock on the handle
12
by turning the
locking knob
11
anticlockwise until the handle
12
moves freely (see Figure G, step
2
).
j
Swivel the umbrella top
8
into the desired
position (see Figure G, step
3
).
j
Lock the handle
12
in place with the locking knob
11
. To do this turn the locking knob
11
in the
clockwise direction to tighten it (see Figure G,
step
4
).
Q
Inclining the umbrella top
j
Release the lock on the handle
12
by turning the
locking knob
11
anticlockwise until the handle
12
moves freely (see Figure H, step
1
).
j
Push the handle
12
downwards until the desired
inclination angle is reached (see Figure H,
step
2
).
j
Lock the handle
12
in place with the locking knob
11
. To do this turn the locking knob
11
in the
clockwise direction to tighten it (see Figure H,
step
3
).
Q
Closing the umbrella top, moving
the hanging umbrella
j
Turn the crank
14
anticlockwise until the umbrella
top
8
is completely closed (see Figure I, step
1
).
j
Push the plastic sleeve
17
on the support rod
16
upwards (see Figure J, step
1
).
j
Pull the arm
7
on the crankcase
15
downwards
(see Figure J, step
2
).
j
Release the lock on the handle
12
by turning the
locking knob
11
anticlockwise until the handle
12
moves freely (see Figure K, step
1
).
j
Push the handle
12
downwards until it lies against
the union nut
13
(see Figure K, step
2
).
