Flora Digital Printing System
Model LJ320P
Copyright 2011@ Shenzhen Runtianzhi Image Technology Co.,Ltd. By Victor Xu
~ 52 ~
Offset Tab
→
X align Check Box
5.5.9 Step Alignment
Step alignment is an important alignment for Y-axis.
If the step is too big, the output will have blank line;
otherwise, the output will have overlap line.
1. Highlight X Align from test drop down list, and send print by click align color icon;
2. The first pass will print dotted line, and the printer will feed media forward, after
that it will print straight line. You may get three possible cases as below:
Figure 1 shows the motor step value when the test was sent is higher than exact
value so we need to increase, by trial and error method you can get the correct
value.
Figure 2 shows the motor step value when the test was sent is lower than exact
value so we need to decrease, by trial and error method you can get the correct
value.
Figure 3 shows the motor step has exact value so no need for any changes. To
determine the exact motor step value setting, you need to bring the broken and
solid lines closer until you can see one single line only.
3. Below is the table where you can find the Step Parameter setting.
Path for setting X alignment:
Print Option Tag
→
Advanced (Test Print Tools Bar
→
Parameter Setting Icon)
→
Motor Tag
→
Page windows
Notice:
Fig. 1 –
Insufficient Media Feeding Step
Fig. 2 –
Excessive Media Feeding Step
Fig. 3 –
Correct Media Feeding Step
Fig.5.5.9-1 Send Step Align
Enlarge View
Fig.5.5.9-2 Motor Tag
