floorex SATELLITE 650 MkII, Инструкция по безопасности и эксплуатации & Перечень запасных частей

Страница: 8 / 18

SATELLITE 650 MkII
1800 FLOOREX
1800 356 673
Page 7
Electrical safety
01. All electrical maintenance and repairs are to be carried out by qualified persons only.
02. CAUTION - Line terminals may be alive when main switch is in the off position. Disconnect the machine completely
before performing any maintenance or repairs.
03. WARNING - DO NOT operate the machine with any electrical panels open.
04. WARNING - The controls on the SAT650 MkII include an over load device. It is there to protect the controls and
motor from irreparable damage. If it trips it indicates a problem. (i.e.; undersize power lead or poor power to your
power supply). Refer earlier in this manual for recommendations on power leads. Rectify the problem or decrease
load on the Satellite 650 by using tooling with more surface area, or place weights supplied on the brackets on
handle for this purpose.
05.
Continuing to use the SATELLITE 650 when constant tripping occurs, VOIDS THE WARRANTY!
06.
Never operate machine in the rain or if heavy moisture is present.
07.
The overload is there to protect you and the machine from harm. DO NOT bypass or adjust the over load in any way.
If it is faulty, only replace with original part that is identical to the faulty one.
08.
Never bypass over current devices in this machine.
09.
Never connect or disconnect power cables with voltage present or while under load.
10.
Disconnect all power connections and observe lock out / tag out procedures before attempting to carry out any
maintenance or repair on any equipment.
11.
Avoid any contact with any rotating parts or driven parts.
12.
Never use equipment that has not been tested and tagged (including cords).
13. Before connecting the machine to power, check the condition of all power leads and cables on, or used in
conjunction with the machine. DO NOT USE it if any faults, cuts, wear marks, etc… Get qualified persons to repair
and re-tag it as required by regulations in your country.
14.
Connect machine to suitable power outlet. Only use heavy duty power lead suitable for high current use (preferably
2.5 mm2 cable), no longer than 15 meters.
15.
If no power is available within the specified distance have a qualified person install a suitable power outlet closer to
your work. Alternatively use 4 mm² cable for up to 40 meters.