Floorex Products Satellite 760-6 Generation3, Инструкция по безопасности, эксплуатации и каталог запасных частей

Страница: 9 / 24

Page 8 / 24 SATELLITE 760 Generation3
1800 356 673 Floorex Products
Tooling position & Magnetic plugs
To remove tooling from the magnetic plugs, Tilt the machine to the tooling position as per instructions in the
operating instructions and grasp hold of the diamond disk and give it a sharp pull away from the main black
disk.
To remove the plug from the main black disk strike the black disk beside the taper insert as shown below.
The magnetic plugs must be cleaned from dust and other debris every time you change satellite disks. The
insert should go in all the way up into the plug up to the step on the insert. If not, Clean out the hole in the
plug where the insert goes. Ensure there are no particles or pieces of steel (such as staples ETC). The hole
where the insert goes in the plug can be cleaned with a screwdriver to remove packed dust etc.
Ensure the insert is not worn to less than 20mm diameter where the blade runs on the insert. This is
equivalent to the diameter of the section above it.
Put the insert through the satellite disk and install the two parts onto the plug ensuring the insert goes
completely into the plug.