Floorex Products Satellite 480 Generation3, Инструкция по безопасности и эксплуатации

Страница: 9 / 29

SATELLITE 480 Generation3 Page 8
1800 356 673 Floorex Products
Tooling position & Magnetic plugs
59. It is very important to remove all plugs from the unit before installing standard Diamond Plugs. This includes
Magnetic and for the SP machines, the SP Drive System.
60. To remove tooling from the magnetic plugs, Tilt the machine to the tooling position as per instructions in the
operating instructions and grasp hold of the diamond disk and give it a sharp pull away from the main black
disk.
61. To remove the plug from the main black disk strike the black disk beside the taper insert as shown below.
62.
63. The magnetic plugs must be cleaned from dust and other debris every time you change satellite disks. The
insert should go in all the way up into the plug up to the step on the insert.
64. If the insert is getting signs of wear on the top it is because the insert hole has debris in it or hard packed
dust against the magnet.
65.
66. Clean out the hole in the plug where the insert goes. Ensure there are no particles or pieces of steel (such as
staples ETC). The hole where the insert goes in the plug can be cleaned with a screwdriver to remove packed
dust etc.
If the insert does not go all
the way in it will result in
wear on the face of the insert