15
GETTING
ST
ARTED
SAFETY
/
SPECIFICA
TIONS
ASSEMBL
Y /
INST
ALLA
TION
OPERA
TION
TROUBLESHOOTING
MAINTENANCE
/
REP
AIR
14
OPERATION (continued)
USER CONFIGURATION MODE
General Notes for User Configuration Mode Menus
1. The term “
focus
” as used in this manual indicates an active editable item.
Focused items will constantly flash ON/OFF.
2.
Advance focus:
Toggle (momentarily press) the
Total
button. Advancing focus
will move focus to the next editable item to the right. If already on right most item
the focus will go back to the start position in a round robin fashion. If only (1) item
is editable, advancing focus will move focus to next menu.
3.
Increment the value of editable item:
Toggle the
Rate
button. If editing a
number, the number will increment in a round robin fashion. If editing a text option,
focus will advance thru a predefined list of text depending on the active menu and
item. Advancing to the next item or menu with a unit in focus will select that unit.
4.
Advance focus to next menu:
Press and hold the
Total
button and toggle the
Rate
button.
5.
Retrogress focus back to previous editable item or previous menu:
Press
and hold the
Rate
button and toggle the
Total
button.
6.
Exit any user configuration mode menu:
Press and hold
Total
and
Rate
buttons simultaneously for 3 seconds.
NOTE:
There is a
90 second “no action”
clock
running when in user configuration
mode. After 90 seconds with no button push to reset the clock, the computer will
automatically exit and return to normal operating mode. There is
no automatic
“save”
, all entries made up to that point will be lost.
Entering User Configuration Mode
While in normal operation mode, the user can enter the display user configuration
mode by pressing and holding the
Total
and
Rate
buttons simultaneously for 3
seconds from any screen; the software will display a three second count down
sequence (see Figure 12-1), then reset the display to configuration mode. (See Figure
12-2)
Figure 12-1
NOTE:
After three seconds the LCD will display
“ConFig” on the top row and “Mode” on the bottom
row until the user releases both of the buttons; the
display will then immediately show the first menu
(PIN) of the configuration process menus.
Figure 12-2
NOTE:
If the user releases both or either button before the countdown completes, the
display will return to normal operation mode.
OPERA
TION
Configuration
Mode