Flomec EasyBatch, Инструкция по эксплуатации

Страница: 7 / 24

7
2.2 Operator Functions
By default, the EB11 will act at Operator level. For the Operator, the following functions are
available:

To enter a batch quantity
To change the PRESET-value, following procedure must be followed:
1)
press START + STOP quickly and simultaneously: the word "PROG" will be
flashing, If the buttons are held too long there will be no response
2)
use STOP to select the digit position and START to increase that value,
3)
set the new PRESET-value by pressing START + STOP quickly and
simultaneously.
Fig. 3: Example display information during programming preset value.
When data is altered but START + STOP has not been pressed yet, then the alteration can
still be cancelled by waiting for 20 seconds: the former value will be reinstated.
The PRESET-value can be used time after time till a new value is programmed.

Starting up the batch process
The batch process can only be started up when "READY" is displayed. The batch process is
started-up by pressing the START-key.
Fig. 4: Example display information during the process.